GreenWorks Commercial 2528102 Manuel Opérateur page 6

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Product Safety
EN
SPECIAL RULES
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
The following system is used in the operator manual to make it easier to understand:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired
operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful interference to radio or television
reception, The reception can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC RF exposure requirements, a separation distance of 20cm or more should be maintained between
the antenna of this device and persons during device operation.
To ensure compliance, operations at closer than this distance is not recommended
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be practiced including the following:
1
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
2
Read and follow all instructions that are on the product or provided with the product.
3
For a cord-connected or direct plug-in power unit, do not use an extension cord.
4
Reference the National Electrical Code, NFPA 70, specifically for the installation of wiring and clearances
from power and lighting conductors.
5
Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable
codes and standards, including fire-rated construction.
6
For a cord-connected or direct plug-in power unit, do not install or use within 10 feet of a pool.
For a cord-connected or direct plug-in unit, do not use in a bathroom
7
8
WARNING: Risk of Electric Shock. When used outdoors, install only to a covered Class A GFCI
protected receptacle that is weatherproof with the power unit connected to the receptacle. If one is not
provided, contact a qualified electrician for proper installation. Ensure that the power unit and cord do not
interfere with completely closing the receptacle cover.
9
WARNING! Risk of Fire. Installation involves special wiring methods to run wiring through a building
structure. Consult a qualified electrician.
10 WARNING: Output wiring of PSU more than 6 feet long may introduces a risk of fire, electric shock,
or injury to persons.
SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for
power units.
6
Version 3 - 2021.03.11

Publicité

Table des Matières
loading

Table des Matières