GreenWorks Commercial 2528102 Manuel Opérateur page 17

Installation
Insert both ends of the boundary wire as well as the end of the guide
wire into the splice and guide wire connector. Check that the wires are
fully inserted into the splice and guide wire connector so that the ends
are visible through the splice and guide wire connector.
Squeeze down the button on top of the splice and guide wire connector
fully using a polygrip until you hear a click.
Secure the splice and the boundary and guide wires either using pegs
or by burying.
Connect the guide wire to the charging station as follows:
1 Remove the protective cover on the charging station and thread
G1
the guide wire behind the tabs into the channel leading to the
G2
terminals.
2 Connect the guide wire to the contact pin on the charging station
that is labelled G1.
Installing a second guide wire
1 If you have more than one narrow passage or a complicated
garden you can install a second guide wire. To do this, follow
the steps for installing a guide wire except connecting it to the
contact pin on the charging station marked G2.
EN
17
Version 3 - 2021.03.11