LENCO Classic Phono TT-33 Mode D'emploi page 9

- Plug the supplied AUX IN cord into the AUX IN JACK on the rear of the unit.
- Insert the plug at the other end of the Auxiliary cable into the output jack or 3.5mm dia.
headphone jack of the external audio player.
- Switch the other Audio Player on, play the music and adjust its volume if required.
Note: Inserting the Aux plug will disable the record play function.
5. Trouble shooting
THERE IS NO POWER
* The POWER CORD is not connected to either a power outlet or the unit.
- Check the plugs and whether they are not damaged.
* The unit is not turned on.
Rotate the POWER/VOL switch from the OFF position.
-
THE UNIT KEEPS SHUTTING ITSELF DOWN
* This unit has a POWER SAVING FUNCTION, to comply with ERP Stage II regulations. If the unit is
not operated or there is no signal output for 15 minutes, it will automatically turn itself off.
* Turn the POWER/VOL switch off for approximately 5 seconds and then switch it ON again to re-
activate the unit.
THE TURNTABLE IS NOT ROTATING
* The turn table drive belt may have come off the turn table mechanism and needs to be refitted.
Please contact professionals for
* The AUX IN cable is plugged in. Disconnect it.
MY 45RPM RECORDS DO NOT FIT ON THE TURNTABLE SPINDLE
* Ensure you have placed the 45rpm spindle adaptor on the turn table before installing the
record.
MY RECORD DOES NOT PLAY AT THE CORRECT SPEED
* Switch the speed control switch to the correct one for 33⅓, 45 or 78 rpm records.
MY 33⅓ RECORD WOBBLES WHEN PLACED ON THE TURN TABLE PLATTER
* Make sure you have folded down the ARM LOCK before placing the record on it, or that the
45rpm SPINDLE ADAPTOR has not been left on the turntable platter.
advice on how to re-fit it.
9