Programming; Remote Control; Wireless Keyless Entry; Erase The Memory - Chamberlain 8550W Guide D'utilisation

Programming

Remote Control

Below are the steps to program a new or existing
remote control. Test remote control before
reprogramming.
1. Press and release the
LEARN Button on the
garage door opener.
2. Press the button on the
remote control.
Select Menu > Program > Remote and
follow the on screen prompts.
If your vehicle is equipped with a Homelink
you may require an external adapter depending
on the make, model, and year of your vehicle.
Visit www.homelink.com for additional information.

Wireless Keyless Entry

Refer to the instructions which were provided with your
keyless entry product.
OR
® ,
To Erase the Memory
Erase ALL Remote Controls and Keyless Entries
Press and hold the LEARN button
until the LED goes out
(approximately 6 seconds).
All remote controls and
keyless entries are now erased.
Erase ALL Devices
(Including MyQ ® enabled accessories)
1. Press and hold the LEARN button until the LED
goes out (approximately 6 seconds).
2. Immediately press and hold the LEARN button
until the LED goes out. All codes are now erased.
Erase the Wi-Fi Network from the
Garage Door Opener
Press and hold the black adjustment
button until 3 beeps are heard
(approximately 6 seconds).
®
Erase a MyQ Account
Go to myLiftMaster.com to delete your MyQ account.
LEARN
Button
Black Adjustment Button
7