Use - UFLOOR WOLFF Vario-Stripper SILENT Traduction Du Mode D'emploi Original

3
1
05/2008 Vario-Stripper SILENT ,
Tension
screw
5
2
blade`s width
Messerbreite 1
6 5 4 3 2
#038764Fu

5.0 Use

Assembling the machine
To put the stripper into operation, mount the handle to the hand-
le support with the clamping screws. (Pic. 4)
For your safety the Vario-Stripper SILENT comes with the blade
not mounted. Make sure that the power supply is disconnected
before mounting the blade. (Pic. 2)
The sharp bevel of the blade must always face up and the blade
must sit close to its support.
See also Chapter 4.0 Maintenance, "Changing the blade".
Switching on/off
The Vario-Stripper SILENT is operated with the central
control panel integrated in the handle. Press key button (1)
to switch on the stripper. The impact system will start
immediately.
Move the red lever (2) to switch on/off the drive.
The rotary switch (3) is used to adjust the speed from 2.5
to 16 m/min.
The operating light indicates applied voltage.
Press key button (5) to switch off the stripper.
If the operating light does not show, voltage is not
applied. Try another power outlet or check voltage supply.
If power is interrupted during operation, the Vario-Stripper
SILENT must be switched on again by pressing key button (1).
Use
The Vario-Stripper SILENT removes bonded, flexible floor
coverings in strips. It uses an oscillating system, i.e. the blade
performs a circular movement. This movement results in a
lateral cutting.
This could make the stripper swing sideways if you want to
remove stiff flooring or aggressive adhesive. In this case using
the device may be limited due to its system. Before starting
work, the flooring needs to be cut into strips of the blade's width.
To begin, cut one strip crosswise. Then lift the flooring slightly in
order to get the blade underneath it.
We recommend to cut the first strip at right angles to the main
working direction. By so doing access to the next strips is made
easier. Cut the strips smaller if the floor covering is bonded very
securely, e.g. with an epoxy adhesive.
The blades are sharpened by the floor pavement. Therefore the
blade has to be changed only if it is twisted or becomes worn.
12