Charging Procedure - Carson Expert Charger Lipo Compact Manuel D'instructions

CHARGING PROCEDURE

The Expert Charger LiPo Compact is a smart charger that was specially developed for 2s/3s LiPo batteries.
Thanks to its small size and intuitive design, it is ideal for a wide range of applications.
For safety reasons, we recommend that you always charge the battery in a LiPo charging bag.
Instructions:
1. Connect the charger to a household mains socket using the supplied mains cable. The AC input is AC 100-240V, 50/60Hz.
2. The charger will switch to standby mode and the LEDs will light up green.
3. Connect your battery to the charger. In charging mode, the corresponding LEDs will light up red depending on the battery type (2s
or 3s).
4. When charging is complete, the LEDs will turn green and you should disconnect the battery from the charger.
Note: It is normal for the battery and charger to become warm during the charging process.
Error message:
If none of the LEDs turn red during the charging process:
• The battery is already fully charged
• Check the battery (it may be faulty)
• Inspect the connector/polarity
• The charger is only designed for JST XH 2.54 connectors.
GB // 8