Safety Precautions; Technical Data; Charging Procedure - Carson 2A Manuel D'instructions

SAFETY PRECAUTIONS

Please follow below safety notes otherwise the charger and the
battery can be damaged violently.
• Do not keep it in an environment below 5°C or above 50°C.
• Keep away the charger from dust, damp, rain, heat, direct suns-
hine and vibration. Do not drop it.
• This charger should be used on a heatresistant, nonflammable
and nonconductive surface. Never place it on a car seat, carpet
or similar.
• Do not apply the voltage & current higher than the require-
ments by the manufacturer of the battery.

TECHNICAL DATA

500606069 2A charger:
Input voltage: ~230 V 60Hz
Type of battery: NiMH
Number of cells: 1-6 cells (1.2-7.2V)
Power output: 15 W
Maximum charging current: 2 A
Automatic cut-off: yes
500607013 4A charger set inc. NiMh battery pack and AA
batteries:
Input voltage: ~230 V 60 Hz
Type of battery: NiMH
Number of cells: 1-6 cells (1.2-7.2V)
Power output: 30 W
Maximum charging current: 4 A
Automatic cut-off: yes

Charging procedure

• Connect battery to plug, pay attention to the connector shape,
do not apply force.
• Insert the connector in the power outlet, LED will light up red:
the battery is charging.
• Charging time depends on the battery capacity
GB // 6
• Double check if the battery count and type match your charger
• Never disassemble or alter the charger.
• Do not attempt to charge/discharge nonrechargeable batteries
• Keep the charger far away from children. Never leave the char-
500606070 4A charger:
Input voltage: ~230 V 60 Hz
Type of battery: NiMH
Number of cells: 1-6 cells (1.2-7.2V)
Power output: 30 W
Maximum charging current: 4 A
Automatic cut-off: yes
• LED will light up green, battery is fully charged.
• Charger goes on to trickle charge pulsating at 0,1A.
• Disconnect battery from charge connector and leave to cool
down.
settings.
or damaged batteries with the charger.
ger unsupervised, when it is connected to its power supply.