Charging Procedure - Carson Nimh 2A Manuel D'instructions

CHARGING PROCEDURE

Instructions:
1. Connect the charger to a household mains socket using the supplied mains cable. The AC input is AC 100-240V, 50/60Hz.
2. The charger will switch to standby mode and the LEDs will light/flash up green.
3. Connect your battery to the charger.
4. Press the START/STOP button to start or stop the charging process.
5. In charging mode, the „STATE" LED lights up red.
6. When charging is complete, the LEDs will turn green.
7. Please disconnect the battery from the charger again.
Note: It is normal for the battery and charger to become warm during the charging process.
Error message:
The „STATE" LED does not light up RED during the charging process.
• The battery is already fully charged
• Check the battery (it may be faulty)
• Inspect the connector/polarity
• The charger is only designed for Tamiya connectors
The 'STATE' LED flashes RED during the charging process.
• Battey polarity reversed
GB // 8