Delta MultiChoice 144840-CZ-I Instructions D’installation

Write purchased model number here.
Table of Contents:
Warranties .............................................................................................. Page 2
nstallation nstructions ........................................................................ Pages 3 - 12
Clean and care ...................................................................................... Page 12
Maintenance .......................................................................................... Page 12
Cartridge Summary Reference Sheet .............................................. Page 13
For additional replacement parts,
visit www.deltafaucet.com/service-parts
CA T N: This system/device must be set by the
installer to ensure safe, maximum temperature.
Any change in the setting may raise the discharge
temperature above the limit considered safe and
may lead to hot water burns.
NOTICE TO INSTALLER: CAUTION! – As the
installer of this valve, it is your responsibility
to properly INSTALL and ADJUST this valve
per the instructions given. This valve does
not automatically adjust for inlet temperature
changes, therefore, someone must make the
necessary Rotational Limit Stop adjustments
at the time of installation and further adjustments
may be necessary due to seasonal water
temperature change. YOU MUST inform the
owner/user of this requirement by following the
instructions. f you or the owner/user are unsure
how to properly make these adjustmentsplease
refer to page 6and if still uncertain, call us at
1-800-345-DELTA.
ter installation and adjustment, you must affix
your name, company name and the date you
adjusted the Rotational Limit Stop to the caution
3/11/2022
MultiChoice
Installation Instructions
Owners Manual
13/14 Series
You May Need
label provided and apply or attach the label to
the back side of the closest cabinet door and
the warning label to the water heater.Leave
this Instruction Sheet for the owner's/user's
reference.
WARNING: This pressure balanced or
thermostatic bath valve is designed
to minimize the efects o outlet water
temperature changes due to inlet pressure
changes, commonly caused by dishwashers,
washing machines, toilets and the like. It may
not provide protection from hot water burns
when there is a failure of other temperature
controlling devices elsewhere in the plumbing
system, if the rotational limit stop is not
properly set or if the hot water temperature is
changed after the settings are made or if the
water inlet changes due to seasonal changes.
WARNING:Do not install a shut-of device on
either outlet of this valve. When this type of
device shuts of the water ow, it can de eat
the ability of the valve to balance the hot and
cold water pressures.
1
®
Valve Trim
X00107528
107528 Rev. E