De Dietrich PRO 2.3 SUN 230 Notice De Montage page 23

Table des Matières

Publicité

16.
Place the left top cover plate (33-A) in position
flush left over the baseplates (38-A and 38-B)
and the left side cover plate and slide it
downwards so that its lip is seated against the top
horizontal fixing batten (37).
Remove the protective film from the butyl strip on
the right top cover plate (33-B) and place the right
top cover plate (33-B) in position over the
baseplates with its lip against the horizontal fixing
batten.
17.
Fix the top cover plates in position with a sealing
screw (39) through each baseplate ridge.
Caution:
Do not mix up with 6 x 70 mm (16) screws.
Note:
The butyl strip is highly adhesive – once the
cover plate is in place, its position cannot be
adjusted.
18.
Slide half of the lead piece (46) under the right
end of the upper cover plate.
Adjust the lower side of the lead piece with the
lead skirts of the upper cover plate. Place the
upper side against the fixing batten.
19.
Check the position of the upper left cover plate
and fix it to the fixing batten (37) using a second
3,9 x 25 mm screw (45).
20.
Remove the protective film from the butyl strip on
the right top cover plate (33-B). Place the top
cover plate (33-B) in position over the baseplates
with its lip against the horizontal fixing batten.
Then fix it using 2 screws (45).
21.
Fix the top cover plates in position with a sealing
screw (39) through each baseplate ridge.
GB
45
23
16
46
39
46

Publicité

Table des Matières
loading

Table des Matières