Mixx ANALOG PLUS Guide De L'utilisateur page 7

Note: Make sure you set the record size correctly. Setting, or forgetting to set,
the correct size may give the tonearm the wrong instruction leading to damage
of the stylus.
IMPORTANT:
1. THIS UNIT HAS A FULLY AUTOMATIC MOTORISED TONEARM CONTROL.
Do not use your hands to directly remove the stylus during playback to avoid
damage to the turntable.
2. For a few vinyl records, the turntable will stop, or it will not stop before it gets to the end of the
record. For these records, the turntable system may not recognise the record, and the record will
continue to spin without the tonearm returning to the rest or returning to the beginning of the first
track (when the Repeat button is pressed).
In this case, you will need to press the Stop button
so that the tonearm returns to the tonearm rest or, press the Repeat button
on the front panel and the tonearm will return to the beginning of the first track for playback.
9
STANDBY MODE
When the device does not transmit audio output for a certain amount of time, it will automatically go
into standby mode to save energy.
MAINTENANCE
Avoid touching the stylus tip with your fingers and clean the stylus regularly with a soft brush using
back-and-forth motions. Regularly clean the records with a record cleaning brush and record
cleaning solution. Clean the turntable lid and turntable cabinet with a slightly damp microfibre cloth.
IMPORTANT!
Do not use a cleanser that contains alcohol, benzene or any other harsh chemicals that might
damage the turntable.
REPLACING YOUR STYLUS
Firstly, to remove the stylus, push the top front edge downwards, and it should simply slide
down to be visually out of place. Remove the stylus by pulling it forward and removing it from the
tonearm headshell.
To install the stylus, hold the stylus in its correct orientation and locate the small groove under the
tonearm head shell. Gently slide the stylus into position on the tonearm and push upwards until you
hear or feel a small click, indicating the stylus is correctly in place. If you are struggling to fit your
stylus and needle, please check the plastic casing is visually as it should be, any damage to this
part may prevent it from correctly fitting into place.
Please reach out to Mixx customer service for further assistance and keep hold of the original
packaging materials in case you need to exchange or return any items later.
mixxaudio.com
25 on the remote or
@
support@mixx-io.com
5
10 on the front panel
23 on the remote or
EN