Yakima Y02445 Mode D'emploi

FRONT WHEEL TRAY
SAFETY CLIP (1X)
HITCH BOLT (1X)
LOCK WASHER (1X)
WRENCH (1X)
HEX WRENCH (1X)
• Install This product on 2" OR 1¼" hitch receivers ONLY.
• Do not use with hitch-extenders or with
• Do not install on trailers, campers, or RVs.
• Do not install if spare tire causes interference with bikes, or folded carrier.
• Not for use on bikes with front fenders.
In addition, some undersized receivers may not accept this product. If you do not
know the capabilities of your hitch receiver, consult an automotive professional.
IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE. IMPROPER
ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR TO
OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS PRIOR
TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ
AND UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION
OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE
AND ARE NOT THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A
PROFESSIONAL INSTALLER.
1034426K-1/21
ASSEMBLY (1X)
2" BASE (1X)
(2" HOLDUP ONLY)
REAR WHEEL TRAY
ASSEMBLY (1X)
1 ¼" hitch adapters.
KEY (2X)
HITCHLOCK (1X)
1 1/4" BASE (1X)
(1 1/4" HOLDUP ONLY)
Warranty Registration:
www.yakima.com