Adjusting Setup Items - Set - Sony CDX-GT550UI Mode D'emploi

Adjusting setup items — SET
1
Press and hold the select button.
The setup display appears.
2
Rotate the control dial until the
desired item appears, then press it.
3
Rotate the control dial to select the
setting, then press it.*
The setting is complete.
4
Press (BACK).
The display returns to normal reception/play
mode.
* For CLOCK-ADJ and BTM settings, step 4 is not
necessary.
Note
Displayed items will differ, depending on the source
and setting.
The following items can be set (follow the page
reference for details):
CLOCK-ADJ (Clock Adjust) (page 6)
CT (Clock Time)
Activates the CT function: "ON," "OFF"
(page 11, 12).
BEEP
Activates the beep sound: "ON," "OFF."
AUX-A*
1 (AUX Audio)
Activates the AUX source display: "ON,"
"OFF" (page 21).
AUTO OFF
Shuts off automatically after a desired time
when the unit is turned off: "NO," "30S
(Seconds)," "30M (Minutes)," "60M (Minutes)."
REAR/SUB*
1
Switches the audio output: "SUB-OUT"
(subwoofer), "REAR-OUT" (power amplifier).
DEMO (Demonstration)
Activates the demonstration: "ON," "OFF."
DIMMER
Changes the display brightness: "ON," "OFF."
ILLUM (Illumination)
Changes the illumination color: "1," "2."
M.DISPLAY (Motion Display)
– "SA": to show moving patterns and spectrum
analyzer.
– "OFF": to deactivate the Motion Display.
AUTO SCR (Auto Scroll)
Scrolls long items automatically: "ON," "OFF."
LOCAL (Local Seek Mode)
– "ON": to only tune into stations with stronger
signals.
– "OFF": to tune normal reception.
20
MONO* 2 (Monaural Mode)
Selects monaural reception mode to improve
poor FM reception: "ON," "OFF."
ZAP TIME (Zappin Time)
Selects the playback time for the ZAPPIN
function.
– "Z.TIME-1 (about 6 seconds)," "Z.TIME-2
(about 15 seconds)," "Z.TIME-3 (about 30
seconds)."
ZAP BEEP (Zappin Beep)
Has the beep sound between track passages:
"ON," "OFF."
LPF FREQ* 3 (Low Pass Filter Frequency)
Selects the subwoofer cut-off frequency:
"50Hz," "60Hz," "80Hz," "100Hz," "120Hz."
LPF SLOP* 3 (Low Pass Filter Slope)
Selects the LPF slope: "1," "2," "3."
SW PHASE* 4 (Subwoofer Phase)
Selects the subwoofer phase: "NORM," "REV."
HPF FREQ (High Pass Filter Frequency)
Selects the front/rear speaker cut-off frequency:
"OFF," "50Hz," "60Hz," "80Hz," "100Hz,"
"120Hz."
HPF SLOP (High Pass Filter Slope)
Selects the HPF slope (effective only when HPF
FREQ is set to other than "OFF"): "1," "2," "3."
LOUDNESS (Dynamic Loudness)
Reinforces bass and treble for clear sound at low
volume levels: "ON," "OFF."
BTM (page 11)
*1 When the unit is turned off.
*2 When FM is received.
*3 When the audio output is set to "SUB-OUT" or
Rear Bass Enhancer is set to other than "OFF."
*4 When the audio output is set to "SUB-OUT."