Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
16
16
Problem
Sharpening Port jumps down under pressure
Solutions
•
Sharpening Port engagement teeth are not properly aligned. See
Angle Selection View Port on right side of tool near Fence Knob to
ensure the proper angle selected is fully engaged.
•
You are applying too much downward force during sharpening. Do
not use excessive force.
•
If condition persists, please call a customer service agent for direc-
tion.
Problem
Tool is not sharp
Solutions
•
Back of tool is not flat at the cutting edge.
•
Bevel has not been sharpened all the way to the cutting edge.
•
Burr has been created at cutting edge. Follow repeated 'plunge and
pull' method for best results.
Your
WORK SHARP
is warranted to be free of defects due to
®
workmanship or design for 2 years from the purchase date. If
your
WORK SHARP
®
fails to operate, or if any operating prob-
lem occurs, contact
WORK SHARP
1-800-418-1439
(toll-free USA and Canada only)
1-541-552-1301
Please call 6:00 AM–3:30 PM Pacific Time.
Do not return this product to the store where you purchased
it. Do not attempt any service or repairs other than those sug-
gested by a
WORK SHARP
(TSR). During the period of warranty,
our discretion, repair or replace this product free of charge and
will refund Standard Ground UPS postage or shipping charges
providing that the following conditions are met:
1. A copy of the proof of purchase is provided.
2. The product has been operated for the purpose intended
as described in the operating instructions and has not
been abused or mishandled in any way.
3. The product has not been dismantled and no service or re-
pairs have been attempted other than those suggested
by a
WORK SHARP
Warranty
2-year warranty on all
excludes Glass Wheel, crepe, and abrasives
Technical Service at:
®
Technical Service Representative
®
WORK SHARP
®
TSR.
®
•
Marks from previous (coarser) grit have not yet been removed. Fol-
low grit selection criteria.
Problem
Tool will not stay sharp
Solutions
•
Tool was sharpened to too small of an angle for application. Try a
larger (stronger) bevel angle.
•
The burr at the cutting edge was not removed. Follow repeated
'plunge and pull' method for best results.
•
Try micro beveling your tool for a stronger, more durable cutting
edge.
•
Tools made of softer steels do not hold an edge as long and may need
to be sharpened more often.
For Technical Support
1-800-418-1439 (toll-free USA and Canada only)
1-541-552-1301
Please call 6:00 AM–3:30 PM Pacific Time.
components;
WORK SHARP
®
4. The Return Goods Authorization number (RGA #) (as-
signed by the
shipping label.
Please make certain to package items in such a way as to elim-
inate further damage during shipping. Ship via a traceable car-
rier and properly insure the package. No CODs are accepted.
Unapproved shipping charges are nonrefundable.
Complete and mail back the Warranty Registration & Custom-
er Survey in the
WORK SHARP
www.worksharptools.com
Please Fill in the Following for Your Records.
will, at
WORK SHARP
__________ __________ __________
Date of Purchase:
_____ / _____ / _______
Purchased from:
___________________________________
www.worksharptools.com
www.worksharptools.com
TSR) is written on the
WORK SHARP
®
®
box, or register online at:
Serial Number:
®
Publicité
Table des Matières
