Network Parameters Setting; Setting Network Parameters Via Dhcp; Setting Network Parameters Without Dhcp - CARLO GAVAZZI EM24 E1 Manuel D'emploi

Network parameters setting

Setting network parameters via DHCP

Step Action
1 Install EM24
2 Enable DHCP and exit with End
3 Connect the EM24 to the LAN network to which the PC is connected
Access the Info pages to view the assigned network parameters
4
5 Start UCS software and connect to EM24 via Manual connection> Modbus TCP
6 Enter the IP address displayed on the Info page (see point 4)
7 Access the settings, disable DHCP and assign the required network parameters (assigned by network administrator)

Setting network parameters without DHCP

Step Action
1 Install EM24
2 Disable DHCP (default setting)
3 Connect the PC to the EM24 via Ethernet cable (point to point connection)
Set the PC network properties as follows:
• static IP address
• IP address of the same class as the EM24, e.g. if the IP of EM24 is 192.168.1.10 (default), you can set the PC address to
4
192.168.1.20
• Subnet mask: 255.255.255.0
• Gateway: not necessary
Start UCS software and connect to EM24 via Manual connection> Modbus TCP, enter the EM24 IP address
5
(192.168.1.10 by default)
6 Access the settings and enter the required network parameters
7 Disconnect the Ethernet cable and connect the EM24 to the network to which the Modbus master is connected
EM24 E1 - Instruction manual | CARLO GAVAZZI Controls SpA 7