Master-Slave Mode - Laserworld Ecoline Série Mode D'emploi

8.2. Automatic mode, Stand-alone operation
Set the device to auto mode:
8.3. Music mode, Sound-to-light operation
Set the device to music mode:
Control the music sensitivity with the trim pot at the front panel.
The LED is flashing when the device is triggered.
8.4. DMX-512 mode
Switch 10 must be set to „off", the other switches are used for setting the DMX
address:
Connect a DMX controller to operate the laser.
Use the switches 1 - 9 to set the DMX address of the laser. Each switch
represents a number. To define a number use the preceding number and
multiply it by 2:
1 2 3 4 5
Switch
Number 1 2 4 8 16
The laser uses 9 DMX channels, so make sure that the next device uses an
address that doesn't overlap with this range.
8 / 28
Laserworld EL-230RGB
6 7 8 9 10
32 64 128 256 Mode Switch
Laserworld EL-230RGB
Channel Value
1 0 - 49
50 - 99
100 - 149
150 - 199
200 - 255
2 0 - 255
3 1 - 10
11 - 255
4 1 - 10
11 - 255
5 0 - 255
6 0 - 255
7 0 - 255
8 0 - 255
9 0 - 255
Please note that a pattern can not necessarily be combined with each effect.

8.5. Master-Slave mode

This mode will allow to link up several units together without a controller.
Choose a unit to function as Master, set the dipswitch to select Sound mode
or Automatic mode. The other units must be set to slave mode (Switch 10
must be set to „off"). Use standard XLR cable to chain your units together via
the XLR connector on the rear of the units. After the slave units are turned
„on" they will reset and start in Slave mode to mirror the behaviour of the
master unit.
8.6. Turn laser of
To turn off the device switch it off („OFF"), switch the key to „OFF" and discon-
nect the power cable from the mains.
Function
Laser off
Sound mode
Automatic mode
Static pattern (DMX mode)
Dynamic pattern (DMX mode)
Pattern selection
Center Position on X axis
X axis positioning
Center Position on Y axis
Y axis positioning
Scanning speed
Dynamic pattern speed
Zoom / size
Color
Color segment
9 / 28