Technical Data - Einhell Royal GP-F 1300 Niro Mode D'emploi

Anleitung GP-F 1300 Niro SPK1
GB
4. Applications
Areas of use:
For irrigating and watering parks, vegetable
patches and gardens
For operating lawn sprinklers
With a prefilter, for drawing water from ponds,
streams, rain-butts, rain-water cisterns and wells.
Media which can be pumped:
For the pumping of clear water (fresh water), rain
water or mild suds/dirty water.
5. Operating instructions
Basically, we recommend the use of a prefilter and
an intake set with an intake hose, an intake strainer
and check valve in order to prevent long repriming
times and any unnecessary damage to the pump
caused by stones and hard foreign bodies.

6. Technical data

Mains supply: 230V ~ 50 Hz
Power rating:
Delivery rate max.
Delivery height max.
Delivery pressure max.
Suction height max.
Delivery and intake connection:
Water temperature max.
7. Electrical connections
Connect the power cable to a 230 V 50 Hz
earthed, 10 amp fuse minimum.
The appliance is switched on and off using the
integrated ON/OFF switch.
The motor is protected against overloading or
blocking by an integrated thermostat. In the event
of overheating, the thermostat switches off the
pump automatically. The pump will start up again
automatically after it has cooled down.
8. Assembly of the cable holder
(see Fig. 2)
8
20.03.2006 9:24 Uhr
9. Fitting a suction pipe
Screw the suction pipe (min. 3/4" plastic pipe with
spiral reinforcement) onto the 1" female thread
suction connector (Figure 1/Item 1) of the pump
either directly or with the aid of a threaded nipple.
The intake hose used should have an intake
valve. If the intake valve cannot be used, a check
valve should be installed in the intake line.
The intake hose should rise from the water pick-
up point to the pump. Always avoid laying the
intake line higher than the pump. Air bubbles in
the intake line delay and hinder suction.
The intake and pressure lines must be attached in
such a way that they do not place the pump under
any mechanical strain.
The intake valve should be so far immersed in the
water that the pump cannot run dry even if the
water level falls.
If the intake line is not air-tight, the intake of air
will hinder the intake of water.
Avoid drawing in foreign bodies (sand etc.).
If necessary, install a prefilter for this purpose.
10. Pressure line connection
1100 W
The pressure pipe (min. 3/4") must be connected
4600 l/h
to the 1" female thread pressure pipe connector
48 m
(Figure1/Item2) of the pump either directly or with
the aid of a threaded nipple.
4,8 bar
A 1/2" pressure hose can also be used with the
6 m
appropriate screw connections, of course, but this
will reduce the delivery rate.
1" IG
All shut-off devices (spray nozzles, valves etc.) in
35°C
the pressure line must be fully opened when
priming so that any air in the intake line can
escape.
11. Transport
The garden pump is equipped with a telescopic
transport handle to make it easier to transport
(Figure 3).
12. Starting up
Important! You are allowed to start up the pump only
when it is in horizontal position.
Set up the pump on flat and firm ground.
Attach the intake line ready for use.
Plug into the mains.
Seite 8