AEG DD 8765 Notice D'utilisation page 71

• Fix the sides of the
cooker hood by
fastening the pins (10a)
to the sides of the
fastening screws (10b).
Only DD 8794 (not UK):
side panels are available
as a special accessory
please contact your local
Service Centre (or see
paragraph "Special
Accessory").
Block the sides sliding
the two tabs outwards
(11).
• Make electrical
connection (12), but leave the hood disconnected from the home
mains circuit.
• In the case that it is decided to use the cooker hood in the mains
circuit, then place one of the two flanges provided in the exit hole (13
– Extraction). Attention! The tall flange should be used when a
telescopic chimney is required to be mounted (this item should be
ordered – see special accessories), the short flange is to be used in
all other cases.
• Remount the grease filter and the front panels
according to the numbering
noted also on the back of each
screen (from 1 to 4 from the top
to the bottom).
• Connect the hood to the home
mains circuit and check if the
hood works properly.
1
14
2
3
4
12
Fig. 13
11
Fig. 12
Extraction mode
13
13
Recirculation
mode
10a
10b
71