Installation Requirements - Fs Ipc701-12M-F Guide De Démarrage Rapide

Installation Requirements

Precautions
Make sure the working temperature is maintained at -30°C~60°C, and the relative humidity is ≤
95%.
Keep the camera from excessive pressure, vibration, moisture, dust, and intensive
electromagnetic radiation.
Use a power adapter or a PoE device that meets the requirements. Otherwise, the device may
be damaged.
Make sure the length of the power cable between the power adapter and the camera is not too
long, otherwise the camera might work abnormally because of the lowered voltage. If necessary,
lengthen the cable between the power adapter and the mains.
Do not overbend the cables during the installation. Otherwise, poor cable contact may cause
the camera to malfunction.
Do not hold the tail cable by hand for weight bearing. Otherwise, the cable connector of the
camera could be loosened.
When connecting an external interface, use an existing connection terminal, and ensure that
the cable terminal (latch or clamp) is in good condition and properly fastened.
Ensure that the cable is not tense during mounting, with a proper margin reserved to avoid poor
port contact or loosening caused by shock or shake.
Do not remove the protective lm on the device until mounting is nished. Remove it before
powering on the device.
Contact professionals for maintenance information. Do not attempt to dismantle the device by
yourself. We shall not assume any responsibility for problems caused by unauthorized repair or
maintenance.
3