Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Secure the bottom of the duct with (2) 4.2 x 8 mm
assembly screws.
The range hood is designed to remove smoke, cooking
vapors, and odors from the cooktop area. For best results,
start the hood before cooking and allow it to operate several
minutes after the cooking is complete to clear all smoke and
odors from the kitchen.
The hood controls are located on the front side of the canopy.
A
B
C
D
A. Louver holes (non-vented/
recirculating installations)
B. Duct covers
C. LED lights
D. Canopy
E. Grease filters
F. Grease filter handles
G. Controls
RANGE HOOD USE
G
F
E
Complete Installation
1. For non-vented (recirculating) installations only, install
charcoal filters over grille on blower housing. See the
"Range Hood Care" section.
2. Install metal filters. See the "Range Hood Care" section.
3. Check the operation of the range hood blower and light.
See the "Range Hood Use" section.
NOTE: To get the most efficient use from your new range
hood, read the "Range Hood Use" section.
Range Hood Controls
A
A. On/Off light button
B. Blower off and speed minimum button
C. Blower speed medium button
D. Blower speed maximum button
Operating the light
The On/Off light button controls both lights. Press once
for ON and again for OFF.
Operating the blower
The Blower Speed buttons turn the blower on and control the
blower speed and sound level for quiet operation. The speed
can be changed anytime during fan operation by pressing the
desired Blower Speed button.
Press the Blower Off button a second time to turn the blower off.
B
C
D
11
Publicité
Table des Matières
