Canon imagePROGRAF TZ-30000 Guide D'installation page 11

7
Remove the orange protective caps in the order shown in
the diagram.
Important
● Do not touch the part that was being
protected by the protective cap (part
shown shaded in the diagram) under any
circumstances. Touching it may cause damage
to the print head or printing problems.
● The print head is filled with ink. Be careful to
avoid getting your clothes and surrounding
items dirty when removing the protective
caps. It is recommended that you remove the
protective caps above the bag that contained
the print head.
● Do not reattach the protective caps after
removing them. Dispose of them according to
local regulations.
9
Pull the print head locking cover down toward you to lock
the print head in place.
11
Close the inner cover.
8
Install the print head.
●
Align the print head so that the area enclosed by a circle in the
diagram is facing you, and carefully push the print head firmly
into the printer, ensuring that the part covered by the protective
Hold here to
caps does not touch the carriage.
remove
10
Push the print head lock lever all the way to the end.
12
Close the top cover.
9