Canon imagePROGRAF TZ-30000 Guide D'installation page 10

4
Installing the Print Head
Instructions are now shown on the touch screen regarding print head installation. Install the print head by following the instructions.
1
When the Open the top cover. appears on the touch
screen, open the top cover.
Important
● If the top cover is opened before Open the top cover. appears
on the touch screen, an error may occur. If an error occurs, turn
off the power, close the top cover, then turn the power on.
3
Check that the triangle mark on the angle adjustment
lever is aligned with the red ■. If they are not aligned,
move the angle adjustment lever up or down to align it
with the ■.
5
Open the print head locking cover
instructions on the screen and tap OK. Do not touch the
electrical contacts of the carriage.
Red ■
Triangle mark
by following the
Do not touch here
2
Open the inner cover.
Important
● Do not move the carriage (the area enclosed by a circle in the
diagram). If you accidentally move it, temporarily close the inner
cover and top cover and it will return to its original position.
4
Tilt the print head lock lever
6
Grasp the print head as shown in the diagram and
remove it from the bag.
8
towards you.
Hold here