Attaching The Handle - Provo Craft Cuttlebug Mode D'emploi

Attaching the handle

• Positionhandleon machine post
and insert screw into handle.
Setting up
I. To activate the Cuttlebug machine's suction system, place the machine on a dry,
flat, and smooth surface where it can have 15 inches of space in front and back.
2. Lower both platforms at the same time by pressing them down until they are
perpendicular to the Cuttlebug machine. Lowering the platforms activates the
suction mechanism that willhold the Cuttlebug
machine in place.
• Turn screw with hexkeytool
untiltight.
Fig 3
• Placeplasticcap.