Meec tools 024341 Instructions D'utilisation page 56

EN
Always wear ear protection!
The declared values for vibration and noise,
which have been measured according to a
standardised test method, can be used to
compare different tools with each other and
for a preliminary assessment of exposure. The
measurement values have been determined in
accordance with EN ISO 3744:1995.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
1. Drum
1a. Top part of drum
1b. Bottom part of drum
1c. Rubber seal
1d. Assembly parts*
2. Mixer blade (x2)
3. Motor unit
3a. Power switch I
3b. Power switch O
3c. Power cord with plug
3d. Assembly parts*
4. Wheel holder
4a. Axle*
4b. Assembly parts*
5. Wheel
5a. Wheel (x2)
5b. Washer* (x4)
5c. Cotter pin* (x2)
6. Stand
56
6a. Right stand section
6b. Left stand section
6c. Assembly parts*
7. Leg
7a. Transport handle (x2)
7b. Assembly parts*
7c. Mounting hole (x2)
8. Drum axle
8a. Attachment* (x2)
8b. Assembly parts*
9. Controlwheel
9a. Stop screw*
9b. Spring*
9c. Adjustment screw*
9d. Wing* (x2)
10. Plate to adjust angle
10a. Assembly parts*
10b. Slot*
FIG. 1
NOTE:
Parts marked with * not shown in this
overview. See respective section in the
instructions.
ASSEMBLY
UNPACKING
1. Unpack all the parts and place them on a
level and stable surface.
2. Remove all packaging material and any
transport locking devices.
3. Check that all parts are included and
undamaged. Do not use the product if
parts are missing or damaged – risk of
serious personal injury and/or material
damage. Contact the retailer.
4. Check that personal safety equipment and
all the necessary tools and accessories for
assembly and use are available.
FIG. 2