Fracarro 3DGFLEX Instructions D'emploi page 7

3. OPERATING INSTRUCTIONS
1. Insert the module into the headend (the headend must be OFF)
2. Turn the control unit on and wait for its initialization (the Fracarro logo is displayed)
3. Connect the antenna cables to their relevant inputs.
4. Enter the menu: press the V key, enter the user code (default 1234) and press V again; at this point, the
control unit will perform a scan to find the present modules.
Then program the system as given in the PDF manual which can be download free of charge from the website
www.fracarro.it under the section: prodotti/tvsatellite/3DGFlex
5. With the use of a field meter, check the output signal found at the output connector of the control unit
6. Connect the TV output connector to the distribution cable.
3.1 PROGRAMMING FROM WEB INTERFACE
The easiest way to program the 3DGFLEX control unit is by using the web interface.
To use the web interface, you need a PC and a RJ45 cable.
The procedure is as follows:
1. Connect the PC to the control unit by using a RJ-45 cable of CAT-5E or by using an Ethernet switch.
2. Change the IP of the PC or the control unit so that they are compatible in the same subnet (so that they will
communicate)
For example:
a. Parameters set in the proprieties of the PC network card
IP: 192.168.0.3
SUBNET MASK: 255.255.255.0
GATEWAY: 192.168.0.1
b. Parameters to set in the control unit
IP: 192.168.0.2
SUBNET MASK: 255.255.255.0
GATEWAY: 192.168.0.1
3. Start the Internet browser (recommended browsers: Google Chrome, Mozilla);
4. Enter the IP associated to the 3DGflex in the address bar; the initial window is displayed (fig. 1). Type the user
name and password to enter the home page of the web interface.
DEFAULT PARAMETERS:
USER NAME: admin
7
PASSWORD: 1234