Télécharger Imprimer la page

Extreme Max 3005.3470 Instructions De Montage

Les langues disponibles

Les langues disponibles

Liens rapides

-naäuC7$
Includes:
Number
Description
rv18 Bolt
2.
M8 Nut
3.
M8 Lock
Nut
4.
M6 Countersunk
5.
M6 Lock
Nut
6.
Flat Washer
7.
Hand
Rail
Mounting Plate
8.
Step Section
9.
Lock Pin (Attached to mounting plate)
10.
Read,
Follow,
and Save
Caution
• Always
face the ladder during use.
• Ensure the lock pin is in place before using the ladder.
• Pin the ladder
in place when
• Do not dive or jump from the ladder.
• One person on the ladder at a time.
• Be aware
of potential
pinch
• Check steps and hardware
• Ladder Capacity:
300 lbs. Do not overload.
Product
Satisfaction
At Extreme Max, we pride ourselves
and wish to correct any mistakes on our end. If you are not 100%
satisfied
with the product, for any reason, please reach out to us. We
are here to help!
Warranty
This product is warranted
of retail
purchase.
Warranty
Warranty
valid only in the USA.
This product is warranted
to the original
from defects in material
and workmanship,
expected.
This warranty
shall not apply to any defects
by: (l) overloading,
(II) physical abuse of goods or any acts of
vandalism
by any person, (Ill) improper
to the instructions,
(IV) commercial
warranty
is at the discretion
the same or similar product,
price. Extreme Max M is not responsible
incidental
damages. Any and all freight charges to handle warranty
claims are the responsibility
responsible
for any labor charges that may be incurred.
For all inquries
please
send your
contact phone number,
original
alleged defect and any applicable
com.
Customer Service: service@extrememax.com
Bolt
These
Instructions.
in the flipped-up
position.
points.
before use, replace if broken or worn.
Guarantee
on making quality
for consumer
use for 2 years after the date
includes
parts only.
retail purchaser to be free
ordinary
wear and tear
installation
or use contrary
use. The sole remedy under this
of manufacturer:
the replacement
or the refund of the original
for any consequential
of the consumer.
Extreme MaxTM is not
name,
mailing
address,
retail sales receipt, summary
pictures to service@extrememax.
Flip-Up
Dock Ladder
Assembly
Instructions
Quantity
2
2
2
2
2
8
2
2
3
10
8
4
products
caused
of
purchase
or
main
of
I www.extrememax.com
- 3 Step
3005.3470
- 4 Step
3005.3473
3005.3476 - 5 step
- 6 Step
3005.3907
2
6
7
5
9
3399ex0120
loading

Sommaire des Matières pour Extreme Max 3005.3470

  • Page 1 Extreme Max M is not responsible for any consequential incidental damages. Any and all freight charges to handle warranty claims are the responsibility of the consumer.
  • Page 2 Assembly Instructions - Flip-Up Read all information included on page 1 before beginning operation or installation. 1. Attach each hand rail to the step section using an M6 countersunk bolt and an M6 lock nut. Note: One of the two hand rails features a side equipped with two lock pin holes.
  • Page 3 Assembly Instructions —Stationary Read all information included on page 1 before beginning operation or installation. 1. Attach each hand rail to the step section using an M6 countersunk bolt and an M6 lock nut. Tighten. Stationary Mounting Instructions: Due to the variety of surfaces the Flip-Up Dock Ladder may be fastened to, mounting hardware is not included.
  • Page 4 Flip-Up Dock Ladder -naäuC7$ Instructions De Montage Comprend: 3 Step 3005.3470 4 Step 3005.3473 Numéro Description Quantité 3005.3476 - 5 step M8 Boulon 6 Step 3005.3907 M8 Nut M8 Lock M6 Vis å téte fraisée Boulon M6 Lock Rondelle Plate...
  • Page 5: Montage

    Instructions D'AssembIage - Flip-Up Lisez toutes les informations figurant å la page 1 avant de commencer å utiliser ou å installer. 1. Fixez chaque main courante å la marche en utilisant un boulon å téte fraisée M6 et un écrou de blocage M6. Remarque: I'une des deux mains courantes comporte un cöté...
  • Page 6 Instructions De Montage - Stationnaire Lisez toutes les informations figurant å la page 1 avant de commencer å utiliser ou å installer. 1. Fixez chaque main courante å la marche en utilisant un boulon å téte fraisée M6 et un écrou de blocage Serrer.

Ce manuel est également adapté pour:

3005.34733005.34763005.3907