Extreme Max 3005.4086 Instructions D'installation

-naäuC7$
CAUTION: Usecommon senseand caution when using this product to avoid injury.
Observe the following
- Face the ladder during
- Do not dive or jump from ladder.
- Be aware of potential pinch points.
- Check steps and hardware
- Ladder capacity is 300 lbs., do not overload
Parts Included:
(1) Ladder Assembly
(2) Mounting Cups
(6) Wood Screws
Assembly:
1. Open Ladder hooks and position
WARNING:Be sure your desired
cause damage
etc.
WARNING:Ladder standoffs
pontoon
2. Cut out a circular hole for the cup to fit into.
hole locations. Again you will want to be sure that these locations
3. Drill the 6 holes and install
4. The ladder is now ready for final adjustments.
hang perpendicular to the surface of the water.
done simply remove the rubber caps and remove the desired
reached the desired length simply
Product Satisfaction
At Extreme Max, we pride ourselves
100% satisfied with the product, for any reason, please reach out to us. We are here to help!
Warranty
This product is warranted for consumer
Warranty valid only in the USA.
This product is warranted to the original
wear and tear expected. This warranty
or any acts of vandalism by any person, (Ill) improper
The sole remedy under this warranty
or the refund of the original
Any and all freight charges to handle warranty
responsible for any labor charges that may be incurred.
For all inquries please send your
of alleged defect and any applicable
Customer Service: service@extrememax.com
4-Step
safety protocol:
use.
before use.
ladder.
ladder in desired
mounting
to wires, structural
must be at or below the center line of you
float.
Once the plug has been placed into the hole mark the 6 screw
the fasteners.
reinstall the rubber caps.
Guarantee
on making quality products
use for 2 years after the date of retail purchase. Warranty
retail purchaser to be free from defects in material
shall not apply to any defects caused by: (l) overloading,
is at the discretion
purchase price. Extreme MaxTM is not responsible
claims are the responsibility
name, mailing address,
pictures to service@extrememax.com.
Folding Pontoon
Installation Instructions
Ladder Standoff
mounting area.
location is not going to
supports, fuel tank, hoses,
are clear of obstructions.
Place ladder hoops into the plastic cups. The ladder needs to
If needed the ladder stand offs can be cut. If this needs to be
amount
and wish to correct any mistakes on our end. If you are not
installation or use contrary to the instructions,
of manufacturer: the replacement
for any consequential
of the consumer.
main contact phone number,
I www.extrememax.com
Ladder
3005.4086
of aluminum tubing. Once you have
includes parts only.
and workmanship,
(II) physical abuse of goods
(IV) commercial
of the same or similar
or incidental
Extreme MaxTM is not
original retail sales receipt,
ordinary
use.
product,
damages.
summary
3399ex0120