Extreme Max 3005.4275 Instructions De Montage

-naäuC7$
Includes:
I. Receiver Tube x I
2. Rod Holder Assembly x I
3. Hex Head Bolt x 1
4. Lock Nut x 1
5. Nylon Washer x 2
6. Pivot Pin with Lanyard x 1
7. End cap x 2
Required Tools - Not Included
• 5/8" Hitch Pin
4
1
Read, Follow, and Save These
Warnings:
• Not a bumper.
• Do not exceed the six-rod
• Not to be used as a step.
• Ensure the pivot pin and a hitch pin are in place before travel.
• Remove rods before travel.
Product Satisfaction
At Extreme Max, we pride ourselves
not 100% satisfied With the product, for any reason, please reach out to us. We are here to help!
Warranty
This product is warranted for consumer
Warranty valid only in the USA.
This product is warranted to the original
wear and tear expected. This warranty
of goods or any acts of vandalism
commercial use. The sole remedy under this warranty
or similar product, or the refund
or incidental damages. Any and all freight charges to handle warranty claims are the responsibility
Extreme MaxTM is not responsible
For all inquries please send your
summary of alleged defect and any applicable
Customer Service: service@extrememax.com
Fishing
Assembly
5
00
3
Instructions.
capacity.
Guarantee
on making quality products
use for 2 years after the date of retail purchase. Warranty
retail purchaser
shall not ap ly to any defects caused by: (I) overloading,
by any person, ( II) improper
is at the discretion
of the original purchase
for any labor charges that may be Incurred.
name, mailing address,
pictures to service@extrememax.com.
Rod Holder for 2" Receiver
Instructions
6
and wish to correct any mistakes on our end. If you are
to be free from defects in material and workmanship,
installation or use contrary to the instructions,
of manufacturer:
price. Extreme MaxTM is not responsible
main contact phone number,
I www.extrememax.com
3005.4275
7
2
includes parts only.
ordinary
(II) physical abuse
(IV)
the replacement of the same
for any consequential
of the consumer.
original retail sales receipt,
3399ex0120