Extreme Max 3005.2184 Instructions D'installation

-naäuC7$
DO NOT RETURN THIS PRODUCT
If you're missing parts or have issues installing the product, call our tech line
at (651)357-1862.
Number Part Number
E-710
2 E-711
3 E-712
4 E-713
5 E-714
6 E-715
7 E-716
E-717
8
E-719
9
E-720
10
E-721
II
12 E-722
13 E-723
14 E-724
15 E-725
16 E-726
• Adjusts 28" to 40" high.
•5 angle positions 700 - 900
• 12" of width adjustments
Note:
The included hardware
W x 4-1/2"(10.80cm) H. To mount guide-ons
frames, order one of the following
3005.4050 - Fits trailer frames
3005.4053 - Fits trailer frames
Available at extrememax.com.
1. Clamp Mount Tube Plate Weldments
and bottom of trailer frame. Use Bolts (11) and Lock Nuts (12) to tighten
2. After selecting desired
Mount Tube Plate Weldment
3. After selecting desired Roller height, slide Tube Shims (5) between
tubes (2). Use Hex Bolts (15), Lock Washers
4. Cap Roller Tubes (1) with plastic End Caps (14).
Customer Service: service@extrememax.com
Adjustable
TO YOUR RETAILER.
Description
Roller Tube Weldment
Adjustment Tube
Tube Clamp
Retainer/Clamp Plate
Tube Shim
Roller Shaft; 1/2"(1.27cm) x 13"(33.02cm)
Roller; x
End Roller; 2"(5.08cm)x 2"(5.08cm)
Lock Washer; 3/8"(0.95cm)
Acorn Nut;
Tap Bolt; - 16x
Lock Nut•,
Push-On Cap; 1/2"(1.27cm)
End Cap; 1-3/4"(4.45cm) Sq.
Hex Bolt; - 16 x
Mount Tube Plate Weldment
per side
will fit trailer frames up to 3"(7.62cm)
on larger trailer
hardware kits:
up to 5-1/4"(13.335cm)
up to
11
(16) to trailer
angle of Guide-On use Bolts (15) and Lock Nuts (12) to assemble
(16).
(9) and Acorn
Roller Guide-On
Installation Instructions
Quantity
2
2
2
4
2
2
2
4
2
2
8
12
4
2
6
2
15
H
H
3
12
using Tube Clamps (3) and Retainer/Clamp
clamps.
Roller Tube Weldments
Nuts (10) to assemble
I www.extrememax.com
Assembly &
3005.2184
13
1
2
ØOØ
16
15
4
Plates (4) on top
adjustable tubes (2) to
(1) and adjustable
tubes.
14
10
9
5
3399ex0120