Fortuna POLYFIX Mode D'emploi page 16

For filling the dispenser the first time lift piston se-
veral times just a few until no air bubbles are seen
in the cylinder.
2. Volume setting
Loosen the nut of the volume setting system, set the
desired volume. The upper edge of the fine adjustment
screw shows the volume set. Fix the screw.
For calibrating purposes turn the screw of the fine ad-
justment. Turn downwards to increase the volume, turn
upwards to decrease the volume.
Warning:
If the stopper cap is not removed when dispen-
sing, there may be an over-pressure in the channel
system and uncontrolled dispensing may be the
consequence.
16