Babyauto Konar AB710A Notice D'instruction page 22

2. SEAT PARTS AND FITTINGS
A. Cover.
B Group 2 and 3 vertical belt hook.
C. Harness pads.
D. Ergo seat cushion for group 1.
E. Harness straps.
F. Buckle release-button.
G. Locking buckle.
H. Harness adjustment button.
I. Harness adjuster strap.
J. Diagonal belt hook.
K. Childs´s seat base
L. Locking clip.
M. Harness strap slot.
N. Harness pad connector.
O. Group 1 vertical and diagonal belt hook.
P. Harness straps.
Q. Metal harness connector.
3. INSTALLING CHILD SEAT. GROUP 1.
WARNING
Always check that the harness straps are suitable for the height of
your child. The shoulders of the child should always be just below the
back slots at a suitable height (3.1).
So as to ensure greater usefulness, when the height of the child
requires the installation of the harness at its maximum height
(position 3) remove the mat as well as change the position of the
buckle to position 2 (3.2 and 3.3). Rotate plate attached to the safety
buckle to match the groove and insert into the slots of the base of
the seat and then through the slots in the sleeve, then insert into
another slot by turning the plate again until adjusted (3.4, 3.5 y 3.6).
1. Fit this child seat into the vehicle´s seat, making sure it is firmly
pressed against the vehicle seat backrest (3.1).
22 Child restraint system
Only suitable for Group 1, approx.
9 months to 4 years of age (9-18 Kg.)
KONAR