Axis TQ1818-E Guide D'installation page 22

11. Place the transparent base unit cover on the base unit and fit the cable gaskets inside the
holes.
240 mm
(10 in)
NOTICE
To not accidentally disconnect the unit from power if the cable is pulled, let the protective
grounding wire be about 10 mm (0.4 in) longer than the other two wires (in the power cable).
Note
To make the installation as easy as possible, we recommend you to strip approximately 90 mm
(3.5 in) of the power cable jacket and 70 mm (2.8 in) of the I/O cable jacket.
12. Install the power and I/O connectors.
13. Adjust the network, I/O and power cables so that the distance from the cable gasket to the
end of the connector is 240 mm (10 in), 170 mm (7 in), and 160 mm (7 in) respectively.
NOTICE
Make sure that the O-ring is fitted correctly around the transparent base unit cover.
170 mm
(7 in)
1 I/O connector
2 Power connector
3 O-ring
1 2
22
160 mm
(7 in)
3