Axis TQ1818-E Guide D'installation page 19

1
4
1
2
3
4
1. Install the optional conduit adapters (not included).
2. Insert the power cable through the hole in the base unit as shown in the illustration above.
Alternatively, insert it through the bottom cable hole.
3. Pull back the power cable sleeve by 530 mm (21 in), and then insert the power cable through
the strain relief.
4. Fasten the green/yellow wire to the included ring cable lug and connect it to the grounding
screw. The minimum required cable cross-sectional area is 18 AWG (0.82 mm²).
530 mm
(21 in)
Power cable (not included)
Strain relief
Grounding screw
Bottom cable hole
19
3
2
EN