DS Produkte 3186-1 Mode D'emploi page 21

If you want to use the mixing container:
– Screw the cross-blade attachment onto the mixing container (see the "Accesso-
ries" chapter, "Cross-blade attachment" section).
– Turn the lid of the mixing container anticlockwise and remove the lid.
– Pour the ingredients you want into the container and then close the lid again. Make
sure that the lid sits on the container so that the pouring spout is completely closed
shut!
• If you want to use the sieve insert, fi rst place the insert into the (empty!)
mixing container. Make sure that the little bars inside the container sit
correctly in the notches in the sieve insert.
• For juicing, you should only feed the pieces of fruit or vegetables into
the mixing container after the device has been switched on (see step 5).
6. To switch off the device, turn the container anticlockwise again until you feel some
resistance. Always wait until the blades have come to a complete standstill before
you remove the container.
3. Now place the fi lled container into the motor unit (the
blade attachment is "sunk" into the motor unit; see illus-
tration). Make sure that the locking lugs on the beaker
or mixing container rest correctly in the recesses of the
motor unit.
4. Insert the mains plug into a properly installed mains so-
cket that is easily accessible.
5. To switch on the device, press the container down slightly
and at the same time turn it clockwise until it engages.
Always keep hold of the motor unit with one hand while
preparing food.
If you are using the mixing container, remove the insert in
the middle of the lid to add ingredients. You can use the
plunger to continuously feed in more ingredients.
21