Progress Lighting 3266 Instructions De Montage Et D'installation

OGRESS
LIGHTING
WARNING - If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full
compliance with N E.C. requirements.
CAUTION - All glass IS fragile, use care when handling Glass Shade and lamps
WARNING - This product contains chemicals known to the State of California to cause cancer, birth defects and [or
other reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
1.- Fasten Mounting Strap (1) to Outlet Box (2) (NOT INCLUDED) With Mounting Screws (3) from Outlet Box (2).
Thread Nipple (4) and Green Ground Screw (5) into Mounting Strap (1)
2.- Connect Fixture Wires (6) to Supply Wires (7) as shown on Wiring Diagram
3.. Slip Wall Plate (8) over Nipple (4) and secure in place with Knob (9). (DO NOT OVERTIGHTEN)
4.- Slip Glass Shade (10) up over Socket (11) and inside Fitter (12). Secure in place with Socket Ring (13)
(DO NOT OVERTIGHTEN)
5.- Install lamp. (NOT FURNISHED)
2
IJU
7
3
Assembly
CAUTION: Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation
If there are any questions, contact a Qualified Electrical Contractor.
8
1
5
4
6
& Installation
3266
9
PAGE 1 of 2
Instructions
13
10
11
12
WHITE SUPPLY WHITE OR IDENTIFIED
WIRE FIXTURE WIRE
UL LISTED
WIRE-NUTS
BLACK SUPPLY PLAIN OR BLACK
WIRE F XTURE WIRE
BARE, OR GREEN BARE, OR GREEN
GROUND WIRE FIXTURE GROUND
FROM SUPPLY WIRE
OR
BARE, OR GREEN
GREEN GROUND
SCREW
GROUND WIRE
FROM SUPPLY
SPEC NO 022216 10-22-08