Gorgy Timing LEDI 2S NTP Mode D'emploi page 16

WArnInG! read the section that follows very carefully before installing your equipment. It
gives the safety instructions to follow during installation.
the electrical installation to which the equipment is connected must comply with the nF C
15-100 standard.
this device does not have a primary power switch. A power protection system (circuit-brea-
ker or disconnecting switch), that is easy to access must be built into the wiring installation.
This device must support the nominal voltage and current values specified on the clock.
In Europe: to comply with European regulations on the protection of persons and the envi-
ronment, you must dispose of this equipment in a collection site provided for this purpose
(separately from household waste). Contact your reseller, collection site or the competent
lcoal authorities for more information.
Modifying or opening the product without the consent of the Customer service
department will void the warranty.
All maintenance operation shall be conducted with power shut off, including systems connec-
ted on relay outputs if any.
Generally, the power cable (220v) and transmission cable (of time signal) shall not be very
close to each other, so as to avoid interference (keep the distance of a few centimeters).
Gorgy timing disclaims all responsibility in case of accident or damage caused by an impro-
per use of the product.
GORGY TIMING products are compliant with the following standards: CE, EN 60950,
EN 55022, EN 50024
16
IMPORTaNT SaFETY INSTRUCTIONS
MDE-LEDI-2S-NTP-1108V1.0