WHAT YOU'LL NEED
•
Drill and or Phillips #2 screwdriver
•
1/4" drill bit for pilot holes
•
1/4" drill bit for wall anchors
•
15/64" (6mm) long drill bit (Choose the right drill bit based on the
surface material)
REGULATORY INFORMATION
FCC STATEMENT: This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may not cause harmful
interference. (2) This device must accept any interference received, including inter-
ference that may cause undesired operation. This equipment complies with FCC
radiation exposure limits set forth for an uncontrolled environment. This equip-
ment should be installed and operated with a minimum distance of 20cm between
the radiator and any part of your body.
FCC WARNING: This equipment has been tested and found to comply with the lim-
its for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IC STATEMENT: This device contains licence-exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and Economic Development Canada's licence-ex-
empt RSS(s). Operation is subject to the following two conditions: (1)This device may
not cause interference. (2)This device must accept any interference, including inter-
ference that may cause undesired operation of the device. This equipment complies
with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
6