Mattel Hot Wheels RC LIGHTYEAR Manuel D'instructions page 2

1: CONTENTS • CONTENIDO • CONTENU • CONTEÚDO
2: FEATURES • CARACTERÍSTICAS • FONCTIONS • FUNÇÕES
SWITCH/PORT COVER
CUBIERTA DEL
INTERRUPTOR/PUERTO
CACHE
LED INDICATOR
INTERRUPTEUR/PORT
INDICADOR LED
VOYANT DEL TAMPA DO
INDICADOR DE LED BOTÃO/PORTA
BOUTON DE JUMELAGE
ON/OFF SWITCH CHARGE PORT
INTERRUPTOR DE PUERTO DE CARGA
ENCENDIDO/APAGADO
PORT DE RECHARGE
INTERRUPTEUR
PORTA DE
MARCHE/ARRÊT
CARREGAMENTO
BOTÃO LIGA/DESLIGA
LED INDICATOR
INDICADOR LED
VOYANT DEL
DRIVING
INDICADOR DE LED
CONTROLS
CONTROLES DE
CONDUCCIÓN
COMMANDES DE
CONDUITE
CONTROLES DE
DIREÇÃO
PAIRING BUTTON
BOTÓN DE
EMPAREJAMIENTO
BOTÃO DE
EMPARELHAMENTO
ALIGNMENT BUTTONS
BOTONES DE ALINEACIÓN
BOUTONS ALIGNMENT (ALIGNEMENT)
BOTÕES DE ALINHAMENTO
2
3: SET UP • PREPARACIÓN • PRÉPARATION • PREPARAÇÃO
A. REMOTE CONTROLLER BATTERY INSTALLATION • COLOCACIÓN DE LAS PILAS DEL CONTROL REMOTO
INSTALLATION DES PILES DANS LA TÉLÉCOMMANDE • INSTALAÇÃO DAS PILHAS DO CONTROLE
1. Unscrew the battery cover with a Phillips head screwdriver (not included).
2. Install 2 AA (LR6) 1.5V alkaline batteries (not included) with polarity (+/-) as shown inside
the battery compartment. For longer life, use alkaline batteries.
3. Replace battery cover and tighten screw.
4. Replace batteries in the remote controller if the LED on the remote controller does not go on
during a recharge or if the vehicle does not respond well after a recharge.
1. Desatornille la tapa del compartimento para pilas con un destornillador Phillips (no incluido).
2. Instala 2 pilas alcalinas AA (LR6) de 1,5 V (no incluidas) con polaridad (+/-), tal como se muestra en el
interior del compartimento de las pilas. Para una mayor duración, usa solo pilas alcalinas.
3. Vuelva a colocar la tapa del compartimento para pilas y apriete el tornillo.
4. Remplaza las pilas del control remoto si la luz LED del control no se enciende durante la recarga o si el
vehículo no responde bien después de una recarga.
1. Dévissez le couvercle de la batterie avec un tournevis cruciforme (non inclus).
2. Installer 2 piles alcalines AA (LR6) de 1,5 V (non fournies) en respectant le sens des polarités (+/–)
BOOST BUTTON
indiqué à l'intérieur du compartiment des piles. Utiliser des piles alcalines pour une autonomie prolongée.
BOTÓN DE ACELERACIÓN
3. Replacez le couvercle du compartiment des piles et serrez la vis.
BOUTON TURBO
4. Remplacer les piles de la télécommande si le voyant à DEL de la télécommande ne s'allume pas pendant la recharge ou si le véhicule ne
BOTÃO DO ACELERADOR
répond pas après une recharge.
1. Desparafuse a tampa da bateria com uma chave Phillips (não incluída).
2. Instale 2 pilhas alcalinas AA (LR6) de 1,5 V (não incluídas) com a polaridade (+/-) indicada dentro do compartimento. Para maior durabilidade,
use pilhas alcalinas.
3. Reposicione a tampa da bateria e aperte o parafuso.
4. Substitua as pilhas do controle remoto se o LED do controle remoto não acender durante uma recarga ou se o veículo não responder bem
após uma recarga.
B. CHARGING THE VEHICLE • CARGAR EL VEHÍCULO • CHARGE DU VÉHICULE • COMO CARREGAR O VEÍCULO
The vehicle is powered by a permanently installed Lithium-ion (Li-ion)
battery,and it must be fully charged before first use.
1. Remove the switch/port cover.
2. Switch off the vehicle by sliding the power switch to OFF (O/ ).
3. Connect one end of the charge cord to the vehicle's charge port and plug
the other end in to a 5V/1000 mAH USB charger (not included).
4. Charging will begin when the cord is connected. A red LED on the vehicle
will slowly flash as the vehicle is charging.
5. The red LED will stop flashing but remain on for a while when the vehicle is
fully charged. Unplug the charge cord when charging is complete. A full
charge will usually take approximately 20 minutes. Charging time may
vary.
6. Reattach the switch/port cover.
7. Recharge the vehicle if the vehicle LED rapidly flashes then goes off during
play or if the vehicle begins to respond slowly.
NOTE: Power switch must be in the OFF (O/ ) position when charging
the vehicle.
AA (LR6) 1.5V
3
x2