PRO-POINT CREEPER Mode D'emploi page 6

8735086
2. Attach the front
casters (J) by
inserting the stem
of each caster
through the end of
each leg and
securing it with a
flange nut (U).
Install the rear locking casters (K) to the base frame in the same manner.
Lock the rear wheels in place for the remainder of the installation.
Install the ladder assembly (B) by
3.
inserting a frame bolt (N) through each
side of the base
ladder assembly. Secure ach bolt with
a lock nut 1 (V). Swing the ladder's
angle support (Fig. 3-1) into the height
adjustment notches (Fig. 3-2). Make
sure the crossbar is firmly in place.
Place the leg cross support (G) on
4.
both legs (E & F), aligning the bolt
holes. Insert a cross support bolt (O)
through the each end of the leg cross
support and leg. Slide a washer (T)
over one bolt
nut 2 (W). Repeat with the other
cross support
Attach the height
5.
adjustment
Match the angled opening
with the adjustment
notches. Insert a height
adjustment
through the bolt hole at
each end of the plate.
Secure each
lock nut 2 (W). Repeat on
the other side.
6
Foldable
frame and
and secure with
bolt.
plate (Q).
plate bolt (R)
bolt with a
Topside Creeper
lower
a lock
For technical
Q
G
questions call 1-800-665-8685
Vl.l
Fig. 2
3-1
3-2
Fig. 3
Fig. 4