PRO-POINT CREEPER Mode D'emploi page 5

Vl.l
UNPACKING
WARNING! Do not operate
the missing part before
malfunction and personal
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the contents
Contents:
A Base Frame
B Ladder Assembly
C Chest Deck
D Chest Deck
E Right Leg
F Left Leg
Leg Cross Support
G
Pouch
H
Pouch Bracket
J Front Casters (2)
Rear Casters (2)
K
L Bumper Pads (3)
ASSEMBLY
Letter references
1. Assemble
end of each leg into the base frame's openings
The height adjustment
notches (Fig. 1-1) will be on
the inside and the legs must
angle outwards. Secure
each leg with a frame bolt
(N) and lock nut 1 (V).
Insert the two leg lock pins
(M) and push the ends
down to secure the legs.
Visit www.princessauto.com
Foldable
the tool if any part is missing.
operating.
injury.
frame
Pad
& INSTALLATION
in parenthesis
the right and left legs (E & F) to the base frame (A). Insert the
for more information
Topside Creeper
Failure
are included.
M Leg Lock Pin (2)
N Frame Bolts (4)
O Cross Support Bolts (2)
P Chest Frame Bolts (6)
Q Height Adjustment
R
Height Adjustment Plate Bolts (4)
Phillips Screws (4)
S
T Washers x 2
Flange Nut x 4
U
V Lock Nut 1 (4)
Lock Nut 2 (8)
w
x Lock Nut 3 (6)
(A) refer to the contents.
to do so could
Plate (2)
and align the bolt holes.
8735086
Replace
result in a
Fig. 1
5