Power Limitation Configuration - SCHOCK STIB64BKM Notice D'utilisation

Power limitation configuration

Before you start the procedure :
• Disconnect the appliance from the electrical network by removing the fuse or turning the
circuit breaker off
• Reconnect the table to the electrical network.
• It is necessary to start the procedure within 2 minutes after the connection of the hob to
the electrical network.
• Do not press the [
Modification of the limitation of power:
1) Press the key n°2 and hold down.
2) The symbol [ ] will appear on each display
3) With your other hand, press successively and
quickly (less than 2s) on each [ ] display. Begin
from the front right side and turn contrary clockwise
as described on the picture (a -> b -> c -> d)).
A double "beep" means an error occurred.
If so, start again from item 1).
4) Remove the fingers of the keys. In the back left display a "C" and a"0" appear flashing
alternately. Meanwhile a standing "0" is displayed in the font left zone.
5) Select the back left key, then change "C0" in "C1" by means of position of your finger at
the end of the "SLIDER".
6) Select the front left key.
7) Program the desired configuration wished by means of the "SLIDER", the beginning to
decrease and the end to increase:
- config 0: 7,1kW
- config 1: 2,9kW
- config 2: 3,7kW
- config 3: 6,0kW
8) Select key n°1 during 2s to validate the configuration.
The total power of the hob when delivered is limited to 7100 W.
] key.
13
c
d
b
a