Power Management; Power Limitation Configuration - SCHOCK STIB64BKE Notice D'utilisation

Power management

The hob is equipped with a power limitation.
If the selected heating levels for both zones exceed the maximum available amount of power, the
power management function is automatically reducing the power from one of these zones. The
display of this zone is first blinking; the level is then automatically reduced to the highest suitable
position.
This limitation is set at 7400W by the factory but it is possible to change it to 1400 W, 2100 W,
2800 W, 3000 W, 3700 W, 4600 W, 5100 W, 5800W, 6700 W or 7400 W.

Power limitation configuration

Before beginning the procedure:
•
Make sure there is no more pot on the hob.
•
Disconnect the appliance from the grid by removing the fuse or turning the circuit breaker off.
•
Reconnect the table to the grid.
•
Start the procedure within 2 minutes after reconnecting the hob to the grid.
•
Make sure all cooking zones are off.
Procedure:
To set the power limitation, you must:
•
Press and keep the finger on key [ B ].
• Then, press on each display in the order « 1-2-3-4 » until you hear a "Beep".
• "C" blinking alternately with "0" (called "C/0") appears on the display (3).
•
The configuration code appears in display (4).
• Press on display (3) and choose by using the slider "C/1".
•
Then press on display (4) and select the power limitation wanted by sliding on the slider:
- 0 correspond to 7400 W
- 1 correspond to 6700 W
- 2 correspond to 5800 W
- 3 correspond to 5100 W
- 4 correspond to 4600 W
- 5 correspond to 3700 W
- 6 correspond to 3000 W
- 7 correspond to 2800 W
- 8 correspond to 2100 W
- 9 correspond to 1400 W
•
Then, press and keep the finger on key [
•
The hob is now ready to be used.
3
4
« SLIDER »
] until all the displays segments disappear.
13
2
1