Frigidaire FRMS2733AV Mode D'emploi page 39

Concern
Ice maker is not making enough
ice.
Freezer ice maker will not stop
making ice (some models).
Potential Cause
Ice maker is producing less ice
than you expect.
The water filter may be clogged
with foreign material.
Saddle valve on cold water pipe
is clogged or restricted by foreign
material.
Heavy traffic, opening or closing
of the doors excessively.
Freezer control is set too warm
(freezer ice maker).
Water pressure is extremely low.
Cut-off and cut-on pressures are
too low (well systems only).
Reverse osmosis system is in re‐
generative phase.
Ice maker bail arm is being held
down by a package in the freezer
that has fallen against ice maker.
Ice cubes are located in once
spot inside the freezer ice bin.
Common solution
• In a standard depth model,
the refrigerator ice maker
should produce 3.2 to 3.7 lbs
of ice per 24 hours and will
hold around 5 lbs of ice.
• In a counter depth model, the
refrigerator ice maker should
produce 3.2 to 3.7 lbs of ice
per 24 hours and will hold
around 4 lbs of ice.
If water dispenses slower than
normal, or if the filter is six
months old or older, it should be
replaced.
Ensure that the supply line does
not kink when the refrigerator is
pushed into place against the
wall.
Turn off household water line
valve. Remove valve. Clean
valve. Replace valve if necessary.
Set freezer control to colder set‐
ting to improve performance of
the ice maker (freezer ice maker).
Allow 24 hours for temperature to
stabilize.
Have someone turn up the cut-off
and cut-on pressure on the water
pump system (well systems only).
It is normal for a reverse osmosis
system to be below 20 psi during
the regenerative phase.
Move any item or frozen ice
cubes that may block the bail arm
from being in the off or upward
position.
Periodically move ice cubes
around the ice bin so that ice
maker will continue to make ice.
ENGLISH 39