Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Using Network Function
Note:
To use the network function, set each "NETWORK SETUP" setting and make sure to set the "CONTROL
I/F SELECT" to "LAN". (see page 4)
When "LAN" is set, power indicator is lit orange when the slot power is turned on, then the power is turned
"OFF" with remote control (stand-by state) regardless of the "Slot power" setting.
For details on the "Slot power" setting, refer to the Operating Instructions of the display unit.
■
Example of Network Connection
COMPUTER
Ferrite core
(supplied)
Hub or broadband router
Notes:
• Lay the LAN cable away from other connection cables (excluding the power cord).
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use "category 5" LAN cable.
• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.
Securing the LAN cable (TH-85PF12U)
Note: In accordance with the Installation Instructions, secure the LAN cable so that it will not become
near the display unit.
■
Command Control
Network function of the unit can control the display in the same way as serial control from a network.
Supported commands
Commands used in the serial control are supported.
For details on serial control commands, refer to the Operating Instructions of the display unit.
Note:
Consult your local Panasonic dealer for detail instructions on command usage.
Less
than
10 cm
LAN cable
LAN
(not supplied)
Ferrite core
(supplied)
Installing the Ferrite core
Less
than
10 cm
Pull back the tabs
(in two places)
When using a pedestal for the installation of the display, use a clamper
supplied with the display to secure the LAN cable. For use with another
method of installation, refer to the corresponding Installation Instructions.
Clamper
AUDIO
P
/C
/R
P
/C
/B
Y/G
R
R
B
B
COMPONENT/RGB IN
Open
Wind the cable
Press the cable
twice
through and close
5
Publicité
Table des Matières
