Table Des Matières; Meanings Of Symbols - Tanaka TCH 22EAP2 Instructions De Sécurité Et Mode D'emploi

English

MEANINGS OF SYMBOLS

NOTE: Some units do not carry them.
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their
meaning before use.
It is important that you read, fully
understand and observe the following
safety precautions
Careless or improper use of the unit may
cause serious or fatal injury.
Read, understand and follow all warnings
and instructions in this manual and on the
unit.
Always wear eye, head and ear protectors
when using this unit.
Choke - Run position (Open)
Choke - Choked position (Closed)
On/Start
Contents
WHAT IS WHAT? ................................................... 3
WARNINGS AND SAFETY INSTRUCTIONS ......... 4
SPECIFICATIONS .................................................. 6
OPERATING PROCEDURES ................................. 6
MAINTENANCE ..................................................... 8
TROUBLESHOOTING.......................................... 11
2
and warnings. Off /Stop
Emergency stop
Fuel and oil mixture
Hot surface
Before using your machine
• Read the manual carefully.
• Check that the cutting equipment is
correctly assembled and adjusted.
• Start the unit and check the carburetor
adjustment. See "MAINTENANCE".