RCB RK15 Instructions D'utilisation Originales page 63

2. INSTALLATION OF FRONT LIGHTS AND
FRONT FENDERS
1
3. FRONT WHEEL INSTALLATION
1. Use the No. 15 open-ended wrench from the 16 in
1 tool to loosen the nut in the figure and remove the
support shaft.
2. Install the front wheel into the front fork claw
and secure it.
Deutsch /
1. Pre-install the headlight
and front fender on the
front fork using the
headlight fixing screws.
2
English / Français / Español / Italiano / Nederlands / Polski
1
Note: Place the disc
brake pad into the disc
brake.
(60)
2
2. Pre-tighten the
nut and tighten the
screw.