Using The Product; Safe Working Load - Direct Healthcare Group SystemRoMedic MiniLift125 Manuel D'utilisation

Using the product

Important Information
• The lift must be assembled according to the assembly instructions provided with the lift.
• The lift may only be used indoors and on a level floor.
• Lifting accessories must be properly trial fitted and tested in relation to the user's needs and functional ability.
• Do not leave the user unattended during a transfer situation.
• Under no circumstances may max. load be exceeded. See section on Safe working load.
• Ensure that the user's feet do not get caught between the footplate and the floor. Ensure that the user's feet do not get
caught between the footplate and the base when adjusting the base width.
• MiniLift125 is not intended for transporting users. It may only be used for short transfers.
• Never move the lift by pulling on the actuator!
•The lift must not be used or immersed in or under water including showering.
• The lift should not be left / stored in a high humidity environment.
• The lift must not be charged in a wet room.
• To ensure optimal function, the lift must be inspected regularly. See section on Maintenance.
• Warranty applies only if repairs or alterations are done by an authorized technician.
• Using lifting accessories other than those approved by Direct Healthcare Group can entail a risk.
• The lift arm must be loaded throughout the entire lowering procedure.
To transfer with MiniLift125, the user must be able to:
• support weight while standing
• understand instructions

Safe working load

Different products on the same lift system (lift unit, sling bar, sling, scales and other lifting accessories) may have different
allowable safe working loads. The lowest allowable safe working load always determines the safe working load of the
assembled system. Always check the safe working loads for the lift and accessories before use. Contact your dealer if
you have any questions.
7