Eaton Metalux RHB Instructions D'installation page 2

Installation Instructions – RHB Base Luminaire
7 . Loosen the 2 screws on top of the adjustable mounting
plate by 1.5 turns, then slide the adjustable mounting
plate until luminaire hangs level, using water level to
assist if necessary. Retighten the 2 screws. (Figure 3)
Figure 3.
8. Remove the screw on the junction box cover on the
front of the luminaire and remove junction box cover.
(Figure 4)
Figure 4.
9. Secure jam nut to the mounting hook threads inside
of junction box and tighten it securely against the
adjustable mounting plate. (Figure 5)
Figure 5.
2
EATON IB519076EN Installation Instructions
10. Feed incoming power into junction box through hole in
mounting hook.
11. Wire according to NEC code. (Figure 6)
Figure 6.
12. Replace junction box cover and reattach cover screw.
Pendant Mount (3/4" NPT)
1. Remove all packaging materials from luminaire.
2. Install optional refractor and/or lenses to the luminaire
according to installation instructions included with
accessories.
3. Feed incoming power wires into junction box through
threaded hole on adjustable mounting plate and fully
thread pendant stem into thread hole on adjustable
mounting plate. (Figure 7)
N otee: Tapered threads of pendant stem will require
significant torque to lock with threads of adjustable
mounting plate.
Figure 7.
Black - Live
White - Neutral
Green - Ground