Bimar M004-L16D3F Notice D'instructions page 17

Use
Attention: the fan can be used only when completely and correctly assembled, that is complete with
its base.
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified
electrician or a person with similar qualifications, in order to avoid any risk.
The fan's functions can be controlled either with the keypad located on the control panel or with
the remote control. The remote control must be pointed at the control panel; for the first use open
the lid and insert the batteries (type AAA), not included.
Do not allow children to replace batteries.
WARNING: Do Not Ingest Battery. Chemical Burn Hazard.
If the cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to
death. Keep new and used batteries away from children. If the battery compartment does not close
securely, stop using the product and keep it away from children. If you think batteries might have
been swallowed or placed inside any part of the body, seek immediate medical attention. The
batteries contain materials, which are hazardous to the environment; they must be removed from
the appliance before it is scrapped and that they are disposed of safely.
Do not mix new and used batteries or batteries of different types.
Should the remote control not be used for long periods remove the batteries.
Insert the plug in the socket.
Ventilation:
1) To turn the fan on, press the key on the remote control "SPEED" or the control panel "
2) To select the desired speed in normal mode "
key: on the control panel shows the selected speed (
Horizontal oscillation (right-left): this is controlled by the "SWING" key on the remote control or the
pushbutton panel (14). To eliminate this motion, press the "SWING" key again.
Vertical inclination (high-low): it is regulated by gripping the motor body and orienting it in the
direction desired; throught the screw (10) to lock the body in the desired position.
Timer: this function allows setting the operating time and the fan will automatically stop at the end.
• To set the operating time, repeatedly press the "TIMER" key on the remote control: every time the
key is pressed, the time set is changed and the indicator light on the control panel lights
corresponding to the time selected (0.5 hour, 1 hour, 2 hours, 4 hours, ecc....): the maximum time
is 7,5 hours. To deactivate the timer, press the button until the timer turns off.
- Mode: the three modes are selected by pressing the "MODE" (15): button:
1. "
": constant ventilation
2. Sleep: (symbol
every half hour, in details:
- Maximum speed set, lamp "
max/medium/minimum speed; then after 30 minutes the cycles are: the fan will run at intermittent
medium/minimum speed and turned off, and the signal lamp on
minimum and off, and the signal lamp on
turned off
), this mode reduces ventilation speed from one speed to the lower speed
", cycles 30 minutes: the fan will run at intermittent
(
", repeatedly press the "
= min;
), and then will switch to low speed until the unit is
17/40
= med; = max).
( ) , then the cycles are: speed
".
" or "SPEED"