Bimar M004-L16D3F Notice D'instructions page 14

Attention: any stickers or advertising material applied to the grid removed before using the
appliance. The manufacturer declines all responsibility in case this is not safe working practices
will be respected.
• Before connecting the appliance, check that the voltage values shown on the data plate
correspond to those of the electricity supply network. In the event of incompatibility between
the electric outlet and the plug of the appliance, have the outlet replaced with another more
suitable type by professionally qualified personnel, who will make sure that the section of the
wires of the outlet is appropriate for the absorbed power of the product. In general, the use of
adapters or extension cords is not recommended; if their use is indispensable, they must conform
to existing safety standards and their current capacity (amperes) must not be less that the
maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• To not place the appliance near sinks or other container of liquids (minimum distance of 2
meters) to avoid the risk of it falling in.
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Do not place the wall fan into the room to avoid the back-flow of gases from the open flue of gas
or other fuel-burning appliances (for duct and partition fans).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
1) Front grille
2) Fan attachment ring nut
3) Fan
4) Grille attachment ring nut
5) Rear grille
6) Motor shaft
7) Body
8) On-speed button
9) Base
10) Screw Adjustable up/down
tilt
11) Screw fix the grids
12) Mounting plate
13) Off button
14) Oscillation button
15) Mode button
16) Timer button
14/40